Bugaboo

How to Install the Bugaboo Wheeled Board

Remove the seat from your Bugaboo stroller and move the handlebar into position over the large rear wheels. Locate the horizontal bar running between the rear wheels which is where the board is installed.

Find the numbers written on the side of each of the clamps included with the wheeled board. The number ending with the letter L goes on the left side and the one ending with the letter R goes on the right.

Turn the clamps so the written sides are facing each other. The openings of the clamps should be facing away from you, with the small extending lips facing inward toward each other.

Position the openings of the clamps against the horizontal bar between the wheels and then push them until the clamps grab on. Slide the left clamp all the way to the left rear wheel and the right clamp to the right side.

Lay the stroller frame down on the right side. The frame should be resting on the right wheels with the left wheels up in the air. Turn the wheeled board on its side so the underside of the board is facing toward the clamps on the frame.

Line up the hooks on the end of the board with the clamps on the frame. Push the hooks up and under the lips on the sides of the clamps and gently rotate the board up toward the handlebar. Turn the frame upright when the board is securely hooked into the clamps.

Lift up the board slightly and slide the loose wheel underneath. Fit the vertical post up inside the hole at the rear of the board and push it up until the wheel snaps into place.

Wrap the hook and loop strap around the central bar of the frame with the elastic band facing behind the stroller. Press the hook into the dip in the middle of the board. When you want to fold up the board, latch the hook in the board onto the elastic band on the central bar.

Tip

Remove the wheeled board by following the installation instructions backward.

Warning

Do not try to install the bar with a child in the stroller or with the seat attached.

How to Replace the Foam Handle on a Bugaboo

Look for the 7- or 14-digit serial number of your Bugaboo stroller on the middle part of the chassis. Try to locate your receipt of purchase. Write down the serial number and have your receipt handy for your conversation with Bugaboo's customer service.

Visit Bugaboo's website which is listed in the Reference section below, or call their customer service line at 1-800-460-2922. Speak to a customer service rep and let them know you need a replacement foam handle. Based on the information you provide them, serial number and purchase date, they will be able to tell you if your handle can be replaced under warranty.

Order a replacement handle over the phone or online if you are no longer under the two-year warranty. Click on the "buy" and "accessories" tab to find and order the handle. If you are under warranty, Bugaboo will send you a replacement foam handle.

Remove the old handle by pushing in the two white buttons located at the base of the existing handle and pulling off the handle. Put the new handle in the handle slots and push until both sides click into place.

Things You Will Need

  • Bugaboo stroller
  • Serial number from the stroller
  • Stroller purchase receipt