How to Build a Pedal Tractor Weight Sled

Tractor pulling is a spectator sport most commonly found at your local county fair 1. There are a number of variations of the traditional tractor pull, including truck pulls and horse pulls. All of these events utilize the same style of sled, a two-wheel sled with skis on the front. As the vehicle moves down the track, a weight is shifted from over the wheels to the skis, which significantly increases the weight of the sled and the difficulty of the pull. Building a child's toy sled can be accomplished with secondhand components.

Remove the front wheels from the toy wagon. If you pry off the red cap at the end of the wheel hub, you will see a retainer clip. After removing this retainer clip, the wheel will simply pull off of the wagon's axle.

Cut the skis to a length of approximately 16 inches. You need to use the curved front lip of the skis, but do not need the back of the skis. Therefore, cut off the back section of the skis. In addition, remove any foot bindings from the skis.

Cut two pieces of 2-by-4 lumber to a length of 8 inches. These will be used as the hubs for the skis. Use an electric drill and wood screws to mount the skis onto the lumber. When looking at the end of each ski, it should form a "T" shape.

Align the skis with the flat side down underneath the wagon. Position the wagon's axle 8 inches from the back of the skis. Hold the wagon approximately level, and then make a mark where the ends of the axle meet the 2-by-4 lumber.

Drill a hole in the lumber with the electric drill to accept the axle. Use a drill bit that is no larger than the axle itself. This will ensure a tight fit.

Insert the ends of the axles into the holes you just drilled, and then place the retaining clip on the end of the axle to hold the skis in place.

Tips

Children should be able to add or remove weight from the front of the sled themselves. Using a basic wagon with an open bed allows them to pretend that they're driving the tractor pull truck without hurting themselves.

Warnings

Installing the moving weight into the sled could cause your child to become injured due to pulled muscles and over-straining. Allow the child to load up her own pretend weights into the wagon to help avoid injury.

Related Articles

  1. How to Remove the Governor From Fisher Price Power Wheels Vehicles
  2. How to Remove a Bicycle's Front Sprocket
  3. How to Make a Sky Bird Kite
  4. Big Wheel Assembly Instructions
  5. How to Make a Toy Car Wheel & Axle
  6. How to Make a Trailer From Plastic Barrels
  7. How to Make Toy Cars Faster
  8. How to Build Gas-Powered RC Cars
  9. DIY Wooden Swingset on a Budget
  10. How to Create a LEGO Mountain
  11. How to Make a Skirt for a RC Hovercraft
  12. How to Troubleshoot Slot Cars
  13. How to Install an Alpha Omega Elite Car Seat
  14. How to make a toy car move by its own power
  15. How to Change Frequency on RC Toys
article divider
×